**Each power switch lights up when activated**
5) The operating temperature is selected by adjustment of the thermostat. The hottest setting will be when the
thermostat is to ‘’HIGH’’, the coolest when it is set to ‘’LOW’’
6) To determine the correct working temperature for your conditions turn the thermostat to ‘’MAX’’ position. The
power light will be activated and the radiator will start to get warm. When the unit reaches the required
temperature, slowly turn the thermostat anticlockwise until the power light goes out. The temperature will now be
kept constant.
7) The first time the heater is used there may be an odour that will disappear after the first 30 minutes of
operation. The odour is due to a lubricant used in the manufacturing of the heater
8) The heater should be serviced by qualified personnel or returned to the manufacturer for servicing
ANTIFREEZE FUNCTION – Turn the unit on and put the thermostat on the antifreeze position. When the ambient
temperature drops to 0c, this function will maintain the room temperature at about 5c.
24 Hour Programmable Timer
1. The timer operates when the slide switch is in the TIMER position
2. To set the timer, rotate the clock dial clockwise, until the current time is aligned with the indicator arrow at the centre
3. For times when you wish the heater to switch on, push the corresponding time segment towards the centre. Each
segment represents around 20 minutes, so if you want the heater continuously on for 2 hours, push 6 segments toward
the centre face
4. NOTE: The dial turns CLOCKWISE ONLY. Forcing the clock face in the other direction will destroy timing gear. The timer
will stop functioning when unplugged or during a power failure. The correct time must be reset when power is restored
IMPORTANT SAFETY INSTRUCTIONS
When using any electrically powered product, basic safety precautions should always be followed, including the
following:
PLEASE READ ALL INSTRAUCTIONS CAREFULLY BEFORE USING THE PRODUCT.
WARNING – to reduce the risk of fire, electrical shock or injury to persons or property:
1. The surfaces of this oil filled radiator heater are hot whilst in operation. Always allow a cool-down period before moving
it to another location
2. Extreme caution is necessary when any heater is used by or near children or invalids and whenever the heater is left
operating unattended
3. Always unplug the heater when not in use
4. Do not operate any heater with a damaged cord or plug or after the heater malfunctions, has been dropped or damaged
in any manner. Return heater to the authorized service facility for examination, electrical or mechanical adjustment, or
repair
5. Do not use outdoors
6. This heater is not intended for use in wet or damp locations. Never locate heater where it may fall into a bathtub or
other water container
7. Do not run cord under carpeting. Do not cover cord with throw rugs, runners. Arrange cord away from traffic area and
where it will not be tripped over
8. To disconnect heater, turn switches to off position, then remove plug from outlet. Pull only by the plug. Do not pull on
the cord when disconnecting it
9. Do not insert or allow foreign objects to enter any ventilation or exhaust opening as this may cause electric shock or
fire, or damage the heater
10. To prevent a possible fire, do not block air intakes or exhaust in any manner
11. Do not use in areas where gasoline, paint, or flammable liquids are used or stored
12. Use this heater only as described in this manual. Any other use not recommended by the manufacturer may cause fire,
electric shock, or injury to persons
13. Avoid the use of an extension cord because the extension cord may overheat and cause a risk of fire
