41
COMPILER TECO/ATI
ENDORSED
DATE
14.07.2003
REG. CODE
1-5302-616
MODEL N°
50898
DATE OF ISSUE
07-03
REVISION
00
XV
101
100
102
STORAGE
Storage
Prepare engines as follows for storage over 30 days
Temporary protection (1/6 months)
•
Let engine run at idling speed in no-load conditions for 15
minutes.
•
Fill crankcase with protection oil MIL-1-644-P9 and let engine
run at 3/4 full speed for 5/10 minutes.
•
When engine is warm empty oil pan and fill with standard new
oil (fig. 100)
•
Remove fuel tube and empty the tank
•
Remove fuel filter, replace cartridge if dirty and refit (fig. 101).
•
Carefully clean cylinder fins, heads and fan (fig. 102).
•
Seal all openings with tape.
•
Remove injectors, pour a spoonful of oil type SAE 30 into the
cylinders and rotate manualy to distribute the oil. Refit injectors.
•
Spray oil type SAE 10W into exhaust and intake manifolds,
rocker arms, valves, tappet etc. Grease all unpainted parts.
•
Loosen belt
•
Wrap the engine in a plastic film.
•
Store in a dry place, if possible not directly on the soil and far
from high voltage electric lines.
Permanent protection (over 6 months)
•
The following is recommended apart from the above
instructions:
•
For the lubrication and injection system as well as for moving
parts use rustproof oil type MIL-L-21260 P10 grade 2, SAE 30
(Ex. ESSO RUST - BAN 623 - AGIP, RUSTIA C. SAE 30) Let the
engine run with rustproof oil and drain any excess.
•
Coat external unpainted surfaces with antirust type MIL-C-
16173D - grade 3 /Ex. ESSO RUST BAN 398 - AGIP, RUSTIA
100/F).
How to prepare the engine for operation
•
Clean engine outside
•
Remove protections and covers
•
Remove antirust with an appropriate solvent or degreaser.
•
Remove injector, fill with standard oil, turn crankshaft by a few
revolutions, remove oil pan and drain the protective oil.
