LOHU 4951L
User Manual
----------------------------------------------------------------------------------------------------------
-----------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------------
Voltlaan 408 – 2681 TV Monster – Netherlands
Tel : +31208080743
Email : [email protected]
Website : www.lohuisnetworks.com
International Numbers:
Dubai :
United States:
United Kingdom:
France :
Italy:
Japan:
Argentina:
Brazil :
Pakistan:
+97142280111
+12123812983
+442033557669
+33170612716
+390662207084
+81345506867
+541152391407
+552135219853
+92217019804
-
8
-
The name must be identical for all devices and points attempting to connect to the
same network. It shall be up to 32 characters length.
Preferred BSSID
- BSSID corresponds to the MAC Address of the Access Point or
Wireless Bridge you want to connect to. Using 00:00:00:00:00:00 as BSSID will make
the device connect to any Access Point based on correct ESSID only.
WLAN Operational Mode
- Wireless LAN Operational mode for the device.
Available modes are:
Access Point
- 802.11a Access Point mode.
Infrastructure Client
- This mode allows connection to any 802.11a based
Access Point.
Polling Client
– This mode allows connection to Lohuis 5G device, utilizing
proprietary Lohuis Polling Wireless MAC Protocol, that has been specifically
optimized for high performance outdoor networks.
AP Client
– This mode allows connection to another Lohuis device or 3rd party
compatible Access Point and full MAC address pass-through in Bridge mode.
PtP Bridge Master
– This mode allows creation of a point to point connection
with another Lohuis device operating in Slave (or Client) mode.
PtP Bridge Slave
– This mode allows creation of a point to point connection
with another Lohuis device operating in Master mode.
WDS
(Wireless Distribution System) – This mode allows device to operate as an
Access Point for other Stations while maintaining connection with other
compatible Access Points operating in WDS mode at the same time. WDS mode
requires all connecting Access Points to operate on the same channel and peer
Access Points MAC addresses need to be configured under Wireless Settings tab.
Please note that WDS works in Bridge mode only.
Mikrotik WDS Client
- This mode allows connection to Mikrotik RouterOS
based Access Point, running in Dynamic WDS mode.
Channel Width
– The channel width device uses - depending on configured
Regulatory Domain available values are 20 MHz (default), 10 MHz or 5 MHz.
Carrier Sense
- This option allows to disable standard 802.11 CSMA/CA backoff
mechanism. Disabling 802.11 CSMA greatly improves performance when operating in
area with noise generated by other (especially non 802.11 compliant) devices.
IP Operational Mode
Bridge
- Bridge works at OSI model Layer 2. This means it does not know anything
about protocols, but just forwards data depending on the destination address in the
data packet. This address is not the IP address, but the MAC (Media Access Control)
