HIBERNATION
To prolong the life of your logger you can hibernate it between trips via
LogTag
®
Analyzer when it is not being used for extended periods. Please
refer to the User Guide in the section about Hibernation.
CALIBRATION
All LogTag
®
products can be calibrated with special utility software,
which will be made available to calibration labs upon request.
Re-calibrated loggers can be identified and traced back to the
calibrating lab thus reducing the risk of fraudulent data tampering.
WATER INGRESS
Please carefully observe the IP rating for your unit and remember that
none of the LogTag
®
products can be immersed into liquids.
ALERT/OK INDICATOR
The symbol is shown as soon as the UTRID-16 has registered an
alarm event. While there are no alarms, the symbol is shown.
RECORDING INDICATORS
The recording indicators show what data the UTRID-16 is currently
collecting.
•
If the word
READY
is shown, the UTRID-16 is ready to be started.
Depending on the configuration it may record pre-start readings.
•
If the symbol is shown, the UTRID-16 is recording temperatures
at the sample interval defined during configuration with LogTag
®
Analyzer.
•
If is shown together with the word
PAUSED
, the product is also
recording, but the recorded values are not taken into account when
calculating alarm events and durations.
If the word
STOPPED
is shown, the UTRID-16 has finished recording
temperature data.
MARK INDICATOR
The word
MARK
is shown when the next temperature reading is
identified with an inspection mark in the recorded data.
CLOCK
The clock display is used to show either:
•
current time,
•
time remaining to start of a delayed start or
•
duration, for example of an alarm.
The display identifies which of those is displayed as follows:
•
If the word
DELAY
is shown, the time value represents a start delay,
or the time remaining until a date/time start will occur.
•
If the word
DURATION
is shown, the time value represents the
duration, for example the time above the upper alarm limit.
•
If the word
DAYS
is shown, the clock represents the number of days
in a delay or duration.
DISPLAY OVERVIEW
Page 3 of 3
•
If the word
HOURS
is shown, the clock represents the number of
hours and minutes in a delay or duration. If none of the above 4 words
are displayed, the clock shows the current time.
MIN/MAX INDICATOR
The word
MAX
is shown when the temperature on the display represents
the maximum recorded temperature for the current trip.
The word
MIN
is shown when the temperature on the display represents
the minumum recorded temperature for the current trip.
ALARM THRESHOLD MARKERS
The upper alarm threshold marker is shown if an alarm event occurred
at one of the upper temperature limits. It is also shown when one of the
upper thrershold values is shown on the review screen.
The lower alarm threshold marker is shown if an alarm event occurred
at one of the lower temperature limits. It is also shown when one of the
lower threshold values is shown on the review screen.
TEMPERATURE UNITS
Depending on the selected PDF temperature units, this shows either °F
or °C.
TEMPERATURE VALUE
This 4 character, 7-segment display shows the last recorded temperature
while the UTRID-16 is recording readings. Once the logger has stopped,
nothing will be displayed.
ALARM ARROWS
The up-arrow is shown when the temperature displayed is above the
specified upper temperature limit. The down-arrow is shown when the
temperature displayed is below the specified lower temperature limit.
The four smaller up/down-arrows are secondary and tertiary alarm
symbols. They are used when more than one upper or more than one
lower alarm is defined and are shown then the current temperature is
above or below the corresponding alarm levels.
