Quick Start Guide
9
C
HAPTER
1
Setting Up the LogLogic Appliance
The
LogLogic Quick Start Guide
provides simple instructions for quickly getting started
with a new Appliance.
After you install the new LogLogic Appliance in its rack and it has power, set it up as
described in this chapter.
You can set up the Appliance either using the user interface via a web browser, or using
the command line interface via a console connection:
Setting Up the Appliance with a Browser . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 9
Setting Up the Appliance using the Console . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . . 11
Once the Appliance is running, you want to configure it for your specific needs. For more
information, see the
LogLogic Users Guide
or
LogLogic Administration Guide
.
To upgrade an existing Appliance, see the
LogLogic Upgrade Guide
.
Setting Up the Appliance with a Browser
To set up a LogLogic Appliance using the browser:
Step 1: Connecting the Appliance to a Network
on page 9
Step 2: Logging in to the Appliance
on page 10
Step 3: Configuring Log Source Auto-Identification
on page 10
Step 4: Configuring Network Settings
on page 10
Step 5: Setting the Time Zone and Time
on page 11
Step 1: Connecting the Appliance to a Network
Connect the Appliance to a network where you can access a 10.0.0.x network address
using a class “C” subnet mask (255.255.255.0). You can also connect to the Appliance via
an Ethernet crossover cable.
Note:
The Appliance’s Default IP Address is 10.0.0.11. The Eth0 port needs to be connected to the
network because that is the only port configured on the Appliance by default at startup. The other
ports will work unless the Eth0 port is connected to the network.
All manuals and user guides at all-guides.com
