Logitek mixIT Audio Console System/JET67 Manual
32
Control Settings
This is where we define microphone mute groups.
Figure 18 - The Control Settings Page, where Mute Groups are defined
For a mute group you must choose the following:
•
Which mix bus you wish to mute (either Monitor (control room) or Studio/Guest
•
Which tally or tallies you wish to turn on (numbers 1-8 are valid)
•
If you check the cue bus, the monitors will be muted with a mic that’s a member of this
mute group is put in cue
•
The Active button must be checked for the mute group to be enabled. If left unchecked
the console will ignore the mute group.
Once you have defined a mute group on this page, go to each microphone input (local or
network) and put the mute group number in the box named Mute Group.
When the first microphone in the group is turned on, the monitors will mute and the tally relays
will turn on and remain so until the last microphone in the group turns off.
There are 10 available mute groups in the system, although most stations use one or two. The
first two mute groups are capable of muting more than one monitor bus. Up to three tallies can
be defined per mute group to turn on multiple on air lights, logging skimmers, and the like.
