Connecting Your Headset to the USB Receiver (PC)
1. With the USB receiver now plugged into the extender stand (preferred) or an available USB port and the
headset in close proximity to the USB receiver, press the Multi-Function Button on the headset for
2 seconds and release to turn on the headset. There is no need to press the button on the USB receiver.
Connection should take place automatically.
Wait approximately 20 seconds, the USB receiver and headset should automatically connect.
When connected you will see 2 blue flashes at regular intervals on the receiver. If your headset is still not
connected, unplug the USB receiver and plug it back in while the headset is on and wait another
20 seconds for conversion to take place.
. Shutting down your computer and headset.
You do not need to unplug your USB receiver when you shut down. However we recommend turning off
your headset to prevent power drain.
Answering a call on the PC.
Your PC must be on with your headset connected and the PC calling application running. When you hear
a ring, simply press the Multi-Function Button a single time to answer the call. When you wish to hang up,
simply press the same Multi-Function Button again.
. Rebooting your PC.
If you have not removed the USB receiver from your computer (or unplugged it from the receiver stand)
simply turn on your headset. After your PC has completely rebooted and is running, simply wait
20 seconds for the headset to reconnect.
. Disconnecting the headset from the receiver (in order to pair it with your mobile phone).
In the CallCentral™ software, select “Disconnect” or press and release the button on the USB receiver
once. This will disconnect the USB receiver.
To learn how to connect your headset to your phone, see the next section (page 8), “Using Your Cordless
Headset with Your Mobile Phone.”
Open the CallCentral™ software.
Click on the disconnect button (note: disconnect can also be accomplished by pressing the button on the
USB receiver once). The LED on the USB receiver will emit a single blue flash.
. Reconnecting your headset to the USB receiver.
Turn on your headset. Plug in the USB receiver if it is not already plugged in. Connection will automatically
be initiated (wait 20 seconds for it to complete).
If receiver is already plugged in, choose connect in the software or press and release the button on the
USB receiver. Both actions will initiate connection. Wait approximately 20 seconds for connection
to complete.
In
st
al
lin
g
t
h
e S
of
tw
ar
e
C
on
n
ec
tin
g
Y
ou
r H
ea
d
se
t
Using the Cordless Headset with Your PC
Note: The headset can be used with only one device at a time, either the PC or a mobile phone.
. Install the software first.
Before plugging in the receiver, the software must be installed.
2. Wait until prompted by the software, and then connect the USB receiver to the convenient extender stand
(preferred) or to an available USB port on your computer.
