SCRUB SINKS USE & INSTALLATION GUIDE
(800) 665-3760
8
|
INSTALLATION
1 Carefully uncrate the Scrub Sink The mounting hardware is under the sink, secured to the shipping materials
• Be sure to remove all hardware before discarding packaging
2 Check water supply and waste terminal locations
• Be sure all connections are safely accessible to the Sink and in proper working condition NOTE: For proper sink operation the
hot water temperature must be 120° F
• Install Sink near a hot water source
3 Locate Infrared sensor-activated sinks near a 110/120V outlet power source
4 Attach wall mount sink support brackets to the wall
• “Z” Brackets for mounting the sink to the wall come with the sink (Fig 5) Recommended mounting specifications for Z brackets
shown in Fig 13 (SS32), Fig 16 (SS64), and Fig 19 (SS96) on
pages 10-12
• IMPORTANT:
IIccoonn TTyyppee
IIccoonn
D
Deessccrriippttiioonn
W
Waarrnniinnggss
(Red triangle with an exclamation point) indicate the potential for minor to
severe injuries up to and including death to personnel.
CCaauuttiioonnss
(Yellow triangle with an exclamation point) indicate the potential for minor
injury to personnel and damage to equipment.
Note: The exclamation point will not be visible where only equipment damage
is present.
B
Buurrnn H
Haazzaarrdd W
Waarrnniinnggss
(Yellow triangle with radiating lines) indicate a potential burn injury to personnel.
EElleeccttrriiccaall W
Waarrnniinnggss
(Yellow triangle with a lightning bolt) indicate a possible shock hazard is present.
Severe shock hazards shall be a lightning bolt in a red triangle.
For wall-mounted units, the wall structure must be capable of supporting the load
• Optional wall mounting systems (in-wall chair carrier and pedestal-style) and their mounting specifications are shown in Fig 15
(part S0001 for sink SS32), Fig 18 (part S0002 for sink SS64), and Fig 21 (part S0003 for sink SS96) on
pages 10-12
5 Install the soap spout on the sink
(see page 9)
6 Mount the sink body onto the Z Brackets that were attached to the wall
• A With the help of an assistant, slide the sink over the “Z” brackets
until it locks securely into place (Fig 6 - Fig 7, Z brackets shown in green)
7 Connect the drainpipe to the drain
8 Connect the water supply to the plumbin
g (page 13)
Fig 5 – Z Brackets
Fig 6 – Z Brackets on Sink
Fig 7 – Cross Section Showing Z Bracket on Sink
