Logik LPV 2250, Руководство пользователя

Страница: 31 / 40

1
General Problem Solving
Problem Possible cause/remedy
No picture/distorted picture... Check the Digital TV Recorder is switched on.
Check the aerial is correctly connected to the Digital TV Recorder.
Check all connections between the Digital TV Recorder and the TV.
Check the TV is displaying the correct AV input (refer to your TV manual).
Check the signal strength (refer to ‘To view the signal strength’ on page 27). •
•
•
•
•
Black and white picture... Digital TV Recorder is set to output Y/C pictures and your TV does no support Y/C. Change the ‘TV Out’ setting
(refer to ‘To choose the type of picture to send to the TV’ on page 23). •
No sound... Check the TV is not muted.
Check the TV volume is turned up.
Check the aerial is connected correctly and the Digital TV Recorder is switched on.
Check all connections between the Digital TV Recorder and TV/Hi-Fi or Surround Sound System. •
•
•
•
No power... Check the power supply is correctly connected and the Digital TV Recorder is switched on. •
Digital TV Recorder does not
work... Check the remote control is in DTV mode. •
Digital TV Recorder takes a long
time to switch on... The Hard Disk is nearly full. Delete some recordings. •
Remote control does not work... Check the remote control mode (for example, when trying to operate the Digital TV Recorder, press the [
DTV
]
button on the remote control and retry).
If the remote control does not operate the TV/DVD player, even when the remtoe control has been set to the
correct mode, re-programme the remote control (refer to ‘Programming the remote control’ on page 28).
Replace the batteries.
•
•
•
Digital TV Recorder does not
record... Format the Hard Disk. Please note that this should only be done as a last resort as formatting the Hard Disk will
permanently delete all recordings. •
Should you experience a problem with your Digital TV Recorder which can’t be resolved using the table below,
put the unit into Standby mode, then unplug completely from the mains. Leave the unit unplugged for at least one
minute before connecting again to the mains.