9
Flame Failure Safety Feature
The flame supervision device (FSD) probe cuts off the gas supply to the burner if the flame is blown out.
When lighting the burner on flame failure models, hold down the control for approximately 5 to 10 seconds after
the burner has lit. Releasing the control too soon will extinguish the flame.
If the flames are accidentally extinguished, turn off the burner and do not try to light it again for at least one
minute (to allow the gas to disperse).
Before Using Your Cooker
Before using your new cooker, please:
• Read this instruction/installation manual, taking special note of the "Safety Warnings" section.
• Make sure all the controls are turned off.
• Turn the mains power on.
Lighting the Hob Burners
1. Choose the control for the burner you want to use.
2. Press the ignition button and at the same time press the control of the burner you want to operate and turn
the control counter-clockwise direction so that the control is at the maximum position. Continue pressing
the ignition button until the burner has lit, and continue holding the control in for approximately 5 to 10
seconds after the burner has lit. Releasing the control too soon will extinguish the flame due to the flame
failure safety feature.
Manual Ignition
(in case of electricity failure)
To ignite one of the burners, press and turn the control counter-clockwise so that the control is at its maximum
position. Hold an ignition source (e.g. candle lighter) close to the upper circumference of the burner.
Move the ignition source away as soon as you see a stable flame. Continue holding the control in for
approximately 5 to 10 seconds after the burner has lit. Releasing the control too soon will extinguish the
flame due to the flame failure safety feature.
3. After ignition, check the flames visually. If you see yellow tipped, lifted or unstable flames; turn the control
off, and check the assembly of the burner rings and caps. Also, make sure that no liquid has entered into the
burner cups. If the burner flames go out accidentally, turn the burners off, and do not try to light them again
for at least 1 minute (to allow the gas to disperse).
4. When turning the hob off, turn the control in a clockwise direction so that the control shows 0 position in
line with the marking on the control panel.
• If the burner does not light within 15 seconds, turn the control off and wait for at least one minute
before trying again.
• To switch the burner off, turn the control clockwise to the 0 position.
• After use, always turn the controls to the 0 position.
This appliance is for cooking purposes only. It must not be used for other purposes, for example
room heating.
Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 9
Logik Free Standing Twin Cavity Gas Cooker LFTG60B16/W16.indd 9
14/12/2020 16:07
14/12/2020 16:07
