Logik L612WM11, Руководство по установке и инструкция пользователя

Страница: 20 / 28

20
There’s not much foam • This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
• The amount of foam can vary, depending on the temperature, level
and softness of your water.
• You may not be using enough detergent.
• You may be using a reduced-foam type of detergent.
• Heavily soiled laundry can reduce the amount of foam.
• Larger loads of laundry can also reduce the amount of foam.
There’s a lot of foam • The amount of foam can vary depending on the temperature, level
and softness of your water.
• You may have used too much detergent.
• The type of detergent you use could cause excess foam.
There’s no foam • This can happen if you’ve put powder detergent directly into the
drum – you must put it in the detergent drawer.
• If your laundry has collected to one side of the drum, water will
be supplied automatically to correct the imbalance – and this will
prevent the foam wash.
• The amount of foam can vary, depending on the temperature, level
and softness of your water.
Fabric softener overflows • You may have exceeded the MAX level in the softener drawer.
• You may have spilt the liquid by closing the softener drawer too
sharply.
There’s a residue of powder
detergent at the end of the
wash This can happen if you’ve put powder detergent directly into the drum –
you must put it in the detergent drawer.
There’s an unusual noise or
vibration • Check there’s nothing metal in the drum.
• Make sure the transit bolts used in transportation have been
removed.
• Check the washing machine is on a flat, stable surface.
There’s a noise when the
water drains away This is normal, it’s the pump starting and stopping.
The electricity supply cuts
out while the washing
machine’s on The washing machine will stop, and won’t start by itself when the power
comes back on. You’ll need to select a programme and start it again.
A circuit breaker trips the
electricity supply • The washing machine will stop, and won’t start by itself when you
reset the breaker.
• You’ll need to find out what caused the breaker to trip, and put this
right. Then reset the breaker, turn your electricity supply back on,
and start the washing machine again.
The water supply is
disrupted When the water comes back on, it may be impure at first.
You’ll need to disconnect the water-supply hose and drain any impure
water through the tap before using your washing machine again.
Remember to re-connect the water supply hose first.
L612WM11_IB_final110406_running change.indd 20 06/04/2011 6:12 PM