Logik L19DVDB10, Инструкция по эксплуатации

Страница: 16 / 60

GB-16
Prepar
ation
Connec
tions
Initial
Setup
U
sing
the
Fea
tur
es
DVR
(Dig
ital
Video
Rec
or
der)
U
sing
the
Fea
tur
es
via
USB
por
t
U
sing
the
DVD
Fea
tur
es
H
in
ts
and
Tips
, Specifica
tion
and
Saf
et
y
W
ar
nings
Connecting a USB Storage Device
Switch off the TV before connecting any USB storage 1.
device.
Connect your USB storage device to the USB port of 2.
your TV.
Plug the connected devices into the mains socket
3.
before switching on the POWER ON/OFF switch
at the side of the TV.
Press the 4. / I button on the top panel of the TV
or the button on the remote control to turn on
your TV and your audio receiver and then set it to
Coaxial mode.
Press the
5. SOURCE button to display the Source
List. Use the buttons to select DTV and then
press the OK button or the button to confirm.
Press the MEDIA button to enter Media Mode.
(Refer to page 35-42 for details.)
• If a hard disk is used, make sure its mains adapter is connected to the mains supply.
If a USB hub is used, make sure its mains adapter is connected to the mains supply as the total current •
consumption may exceed 500mA.
If a USB hub is used, you may refer to the
•
Recording Device on page 38 for details on selecting the
active device when several USB storage devices are connected.
The maximum supported storage space of the hard disk is 1 TB.
•
The file system only supports FAT32 format. •
If you want to store the video streaming of a DTV programme, the transfer rate of the USB storage device •
must not be less than 5MB/s, otherwise the picture and sound of the programme will be affected and
a warning statement will be shown on the screen. If this happens, please upgrade your USB storage
device.
The TV screen will be blank temporarily as it will take time to start up and stabilise the connected hard
•
disk. This is normal and the starting time may vary depending on the brand and the memory size of the
connected hard disk.
Disconnect the USB storage device if it is not in use.
•
Right Rear Side View of TV
USB Cable
Adapter
Portable
hard Disk USB Hub
USB
Connecting Earphones
Connect your earphones to the TV’s socket.
Before putting on earphones, turn the volume down
then put the earphones on and slowly increase the
volume until you reach a comfortable listening level.
Listening to loud sounds for prolonged
periods of time may permanently damage
your hearing.
Right Rear Side View of TV
Earphones Cable
(not included)