Logik L15PEM11, Инструкция по эксплуатации

Страница: 7 / 16

7
3. Distribute the coffee evenly and press it lightly with the
pressing plate (if there is too much coffee, the flow of water
can become blocked).
The unit remains ready for brewing and maintains a
constant heating temperature as long as the Power
switch is left in the ‘
On ’ position. If the temperature
drops, the
Ready
indicator will go off. Please turn
the selector control to the “ Stand-by ” position before
brewing another coffee. The heater will automatically
heat up to the correct brewing temperature and the
ready indicator will illuminate.
If you are experiencing resistance in fitting in the porta
filter, your may use a damp cloth to remove any old
espresso grounds at the infusion head.
Brewing Coffee
1. Make sure the selector control is in the “
Stand-by
” position.
2. When the ready indicator illuminates, the unit is heated up
and ready.
3. Make sure the drip tray is in place.
4. Place one or two pre-heated cups beneath the porta filter.
5. Turn the selector control to the
Coffee
“ ” position.
6. After a few seconds, aromatic coffee will begin to run
through.
7. When sufficient coffee has flowed into the cups, set the
selector control to the “
Stand-by
” position. This will stop the
flow of coffee.
8. If you do not need to use the steam function, set the power
switch to the “
0
” position, unplug the mains cable and allow
the machine to cool down.
9. Remove the porta filter from the infusion head and using
the holding clip to secure the filter in the porta filter, turn
the porta filter upside down to empty the used coffee (used
coffee grounds should be thrown away with domestic waste
and not down the sink which may block drains). Rinse the
filter and porta filter with water and allow to dry.
4. Clean any excess coffee from the rim of the filter to ensure a
proper fit under the brew head.
PUSH
5. Place the porta filter underneath the infusion head so that
the handle is positioned to the left of centre (“
Unlock
“
position). Lift the filter holder until it contacts the brew head
and rotate anti-clockwise until it locks in place (“
Lock
“
position).
Holding Clip
L15PEM11_IB_110408.indd 7 08/04/2011 10:30 AM