GB
8
INSTALLATION
Moving and Installing
Removing the Anchor Bolts
Four anchor bolts keep the interior of the washing machine in place while it’s being moved.
They need to be removed before installation. Use a spanner (not supplied) and follow the instructions
detailed below.
Don’t run the washing machine without removing the bolts, as this can cause excessive
vibrations.
To remove the anchor bolts:
1. Use a spanner to loosen the four bolts. They are located at the rear side of the washing machine.
2. Pull the bolts out horizontally. Make sure the entire bolt is removed.
3. Push the four cover caps (included with your accessories) into the respective bolt holes.
1
2
3
You’ll need the anchor bolts again if you move the washing machine, so make sure you keep
them in a safe place.
Moving the Washing Machine from One Location to Another
Make sure to fix the anchor bolts prior to moving the washing machine.
Before you move the washing machine
• Shut off the tap and run the washing machine to drain the water. Drain any remaining water from
the pump hose.
• Depressurise the water supply hose and remove it.
• Disconnect the mains cable.
• Attach the anchor bolts.
Logik L140WM10E_IB_5L_101011.indb 8
11/10/2010 11:36 AM