3
1.
12VDC Power Output Jack
- This provides constant 12VDC power as long as the battery has a
charge.
2.
Charging indicator LED
- This indicator light will flash as the battery is being charged.
3.
Fully Charged indicator LED
This indicator light will be lit once the battery is fully
charged.
4.
Power Gauge indicator LED s
– The five indicator lights represent the battery’s stored power.
Each indicator LED represents a 20% increment of the total stored power. The 20% indicator
LED will flash when the power level drops to less than 10%.
5.
Check Batt. Button
– This button activates the “Power Gauge” when pressed. The Power
Gauge does not always stay lit so that it can conserve power.
6.
DC Power Receptacle
– This is the socket for the external power supply jack used to charge the
battery.
Operations
The Logicube Battery Pack is designed to be very simple to use. Just follow this procedure:
1.
Attach the DC Power Output Jack from the Battery Pack to your Logicube Drive Duplication
device, refer to the diagram below.
2.
Set up your Logicube Drive Duplication device according to the device’s operations manual.
3.
Start the cloning session. Watch the time remaining and verify that it will fall into the Battery
Pack’s time range.
4.
If the battery does not have enough power to complete the cloning session, attach a second Battery
Pack by plugging its DC Output Jack into the first battery’s charging slot, please refer to the
diagram below. Or you can plug a Logicube External Power Supply into the first battery.
