14
CaretakerSentry®
v3.10
7. If no passcode or an incorrect passcode is entered within 15 seconds,
the CaretakerSentry unit will
hang up and reset.
8. The dealer will press ‘9’ to end programming, exit and reset the CaretakerSentry unit.
Note: The programming voice prompts will still be heard from the base while the unit is being remotely programmed
– this is designed to allow the customer know that changes are being made to their unit.
Adding Additional Pendants to the System:
Note
:
When replacing pendants – due to loss or malfunction,
ERASE ALL PENDANTS
and re-learn just the pendant
that will be used. All pendants are
supervised
and the base will continue to “look” and send failure messages
to the central station for pendants that are no longer working or not currently being used.
SEE SECTION –
ERASING ALL PREVIOUSLY LEARNED PENDANTS
The System comes with one Pendant. If you want to add additional pendants (for a combined total of 9) - follow
the directions here - If not, skip this section.
The Pendant’s unique ID code should already be learned into the Base unit when it came from the factory. You
can add additional Pendants (up to 9) to the System by simply teaching each Pendant’s ID code to the Base unit.
When more than 1 Pendant is learned the base, the base unit will announce the Pendant
number - i.e.” Pendant #X, battery is OK” – when only 1 pendant is learned, the base will only
announce “Battery is OK”
Anytime the Pendant reports to the call center (even with pendant battery status), the pendant number
information is also transmitted to the central station – Zone 1, 2, 3,... for Pendants 1, 2, 3,...
To program a new Pendant to the
Base unit:
On the Base Unit:
1. Push and
release
the RED Code Learn button on the back of the Base unit. You will hear a voice prompt
“Pendant Learning”
On the Pendant:
2. PUSH the Gray Emergency Button on the Pendant.
• If “Base and Pendant out of Range” or, “Pendant Learning Failed” is heard from the pendant,
STOP - wait 30 seconds and start at step
#1 again.
3. When the Pendant Learning has been successful you will hear “Pendant Code Learned”
• I f “Base and Pendant out of Range” or, “Pendant Learning Failed” is heard from the Base or Pendant,
STOP - wait 30 seconds and start at step #1 again
Notes:
•
Yo u have less than 45 seconds after pushing the RED Code Learn button on the base unit to get the pendant
to enter “Pendant Learning” mode.
•
Te a c h i n g additional pendants does not erase previously learned pendants. It adds it to the list.The base
unit will automatically exit the pendant learning mode after several seconds or if Pendant Learning Failed
•
If you hear the voice prompt “Base and Pendant Out of Range” or, “Pendant Learning Failed” an error has
occurred, wait 30 seconds for the base to reset and repeat steps 1 & 2.
•
Only 9 Pendants can be learned. (If Pendants have been lost or replaced, we recommend you erase all pendants
and re-learn all current Pendants.)
