Logic Controls LK7000, Руководство по программированию

Страница: 4 / 22

3
Triggering Modes
Level - Pressing and holding trigger key activates the laser. The laser remains on, and
decode processing continues until trigger key is released, a valid decode, or the
Laser On Time-out is reached.
Pulse - Pressing trigger key activates the laser. The laser remains on and decode
processing continues until a valid decode, or the Laser On Time-out is reached.
Continuous - The laser is always on and decoding.
Blinking - The laser is blinking on & off and decoding. Scanning range is reduced in this
mode.
Time-out Between Same Symbol
When in Continuous triggering mode, this parameter sets the minimum time that must elapse before the
scanner decodes a second bar code which is identical to one which has just been decoded. It is
programmable in 0.1 second increments from 0.0 to 9.9 seconds. To set a time-out value, scan the bar code
below. Next scan two numeric barcodes at the end of this manual. Times less than 1.0 second must have a
leading zero. For example, to set a time-out of 0.5 seconds, scan the bar code below, then scan the “0” and
“5” barcodes. If you make an error, or wish to change your selection, scan the CANCEL barcode.
Beep After Good Decode