Logic Controls LK7000, Руководство по программированию

Страница: 2 / 22

1
Operational Parameters
The Klaser integrated barcode scanner is shipped with the default settings shown below. These
default values are stored in non-volatile memory and are preserved even when the scanner is
powered down.
You can change the default values by scanning the appropriate bar codes included in this manual.
These new values replace the standard default values in memory. The default parameter values
can be recalled by scanning the
SET ALL DEFAULTS bar code.
Parameter Default Value
Beeper Tone Medium Frequency
Laser On Time 3.0 sec
Triggering Mode Level
Time-out Between Same Symbol 1.0 sec
Beep After Good Decode Enable
UPC-A Enable
UPC-E Enable
UPC-E1 Disable
EAN-8 Enable
EAN-13 Enable
Bookland EAN
Disable
Decode UPC/EAN Supplementals Ignore
Transmit UPC-A Check Digit Enable
Transmit UPC-E Check Digit Enable
Transmit UPC-E1 Check Digit Enable
UPC-A Preamble System Character
UPC-E Preamble System Character
UPC-E1 Preamble System Character
USS-128 Enable
UCC/EAN-128 Enable
ISBT 128
Enable
Code 39 Enable
Set Length(s) for Code 39 2-55
Code 39 Check Digit Verification Disable
Transmit Code 39 Check Digit Disable
Code 93 Disable
Set Length(s) for Code 93 4-55
Interleaved 2 of 5 Enable
Set Length(s) for I 2 of 5 14
I 2 of 5 Check Digit Verification Disable
Transmit I 2 of 5 Check Digit Disable
Discrete 2 of 5 Disable
Set Length(s) for D 2 of 5 12
Codabar Disable
NOTIS Editing for Codabar Disable
Set Lengths for Codabar 5-55
Prefix NULL
Suffix 1
LF
Suffix 2 CR
Scan Data Transmission Format Data as is