Logenex
SCDM-SD Series Manual 1.0
5
HARDWARE INSTALLANTION and CONNECTIONS
1.
The unit can be rack mounted in a standard EIA 19” rack. Attach the rack mounts
if the unit is to be installed in a rack.
2.
Use a 75Ω coaxial cable with RCA connectors to connect the
video source
(e.g.,
CATV, DVD, VCR, Camera) to the unit’s
yellow RCA VIDEO INPUT jack
(IN1…IN4 depending on the CSD model).
Repeat this step for each video source connection.
It is highly recommended that quality coaxial cable and connectors be used for all
video source connections.
3. Use RCA cables to connect the
audio source
to the red / white
AUDIO L and
AUDIO R INPUT jacks (
IN1…IN4 depending on the SCDM model). Use the red
and white jacks for audio input or either one for a single input.
Repeat this step for each audio source connection.
Be sure the video and audio connections for each source are consistent with the
unit’s inputs (IN1…IN4 depending on the SCDM-SD model).
It is highly recommended that quality cables and connectors be used for all audio
source connections.
4.
Use a quality 75Ω coaxial cable with “F” connectors from the unit’s
RF OUT jack
to the
distribution system
(combiner or reverse splitter) or directly to a
television.
5. Connect the included 12VDC 3A power supply to
the unit’s
DC 12V POWER
jack.
6. Connect the 12VDC 3A power supply to an appropriately rated AC power outlet.
MODULATOR SETUP AND CONFIGURATION
INITIAL SETUP TO FACTORY
DEFAULT
The
SCDM’s front panel is used to configure the modulator as desired.
Before performing a configuration it is advised that the “Factory Default” settings should
be initialized as follows:
Power up the device and wait until the booting process is complete.
Once complete, press the
Scroll Up/Down button
until “
Default Config
”
appears in the menu. After “Default Config” appears press the
OK button
.
Power down the unit by removing the power supply cable from the DC 12V
power jack.
Wait 5 seconds and re-connect the power supply.
