LOFTNESS 601 EMT, Руководство оператора / Каталог запасных частей

Страница: 13 / 35

Owner’s Manual (Ransomes 951D Series)
N14835 2 - October, 2003 1
Set-up and Operating Instructions
Equipment Set-up:
The initial set-up of this machine will require you to
become familiar with all hazard warnings and safety
precautions listed in this manual. Review the
illustrated parts lists (section 4) to become familiar
with the component parts and how they are
assembled.
The snowblower may be shipped in a wooden
packing crate with the spout and rotator controls
packaged separately. The spout deflector controls
will be pre-assembled onto the spout. Unpack all
components and assemble the spout and rotator
controls onto the snowblower as follows:
1.
Assemble the 1/2” step washers (figure 1, item
#1), 1/2” x 3/8” shoulder bolts and lock nuts
onto the spout gear on one side only of the
spout, but do not tighten down.
Figure1
2. Apply grease onto the spout base ring (figure 2)
Figure 2
•
The electric spout control (figure 4) is pre-
assembled and will use (4) 3/8” bolts, flat
washers, lock washers and nuts to attach the
control onto the bracket as shown, do not
tighten the bolts, then align the spout rotator
gear and the drive sprocket. Tighten the
bolts, and check rotation of spout, adjust if
binding occurs.
3. Slide the spout onto the base ring (figure 3)
checking to insure that the step washers catch
the base ring, install the remaining step
washers, shoulder bolts and lock nuts, then
tighten.
Figure 3
4.
Rotate the spout by hand to check for binding,
re-adjust the bolts if binding occurs as the spout
should rotate freely.
5.
Attach the spout rotator controls onto the
bracket as shown below (figures 4).
.
Figure 4
Attach the wiring harness for the electric
spout control option (figure 5) as follows: