- 6
Deutsch
English
Français
Italiano
Español
Nederlands
Connection
➠
The TV set must be equipped with a
Digital Audiolink
.
You can either connect the subwoofer via a network cable (Cat. 5e or higher) and
the
Converter Digital Audiolink / Audiolink
(included with the Loewe Subwoofer
200, order no. 50212T/U/W30) or you can connect it wirelessly to a compatible au-
dio source via the
Module Wireless AudioLink
which can be optionally retrofitted.
If you wish to connect the subwoofer using the network cable, connect the
Con-
verter Digital Audiolink / Audiolink
to the 25-pin
Audiolink
socket
2
of the
subwoofer. Use the network cable to connect the
Digital Audiolink
of the TV set
to the socket of the
Converter Digital Audiolink / Audiolink
.
Cabling of Loewe TV set (chassis SL2xx) – Subwoofer 200 – speaker
Loewe TV set (SL2xx)
Loewe Subwoofer 200
Mains cable
Connect the speaker cable to the speaker according to the corresponding installa-
tion instructions. One of the two wires is usually marked black. Connect this black
marked cable respectively with the black screw terminal
Speaker Out
3
to the
Subwoofer 200 (connection diagram see figure right) and the black terminal on
the speaker. For this, turn the screw lock of the relevant terminal on the subwoofer
anticlockwise about 5 turns. Guide the wire end into the screw terminal from below
and close the screw terminal by turning it clockwise. Connect the unmarked wires
to the red terminals.
Use the mains cable supplied to connect the 220-240 V socket
4
of the subwoofer
to a 220-240V 50/60 Hz socket.
Converter Digital Audiolink / Audiolink
Front
left
Front
right
Network cable
