Operation
Normal use:
•
Fold down the stand and place the tool in an upright position on a flat surface.
•
Plug the tool into the power supply socket, and switch on the power.
•
Wait 5 - 7 minutes for the tool to reach its normal operating temperature.
•
Squeeze the trigger to advance the glue stick and extrude molten adhesive through the nozzle.
•
To stop extruding adhesive simply release the trigger.
When adhesive can no longer be extruded from the tool, it is time to reload another glue stick.
Once the gluing task is completed place the tool in an upright position on a flat surface (always use the
stand when resting the tool). Ensure that the nozzle cannot cause any damage to surrounding
materials. Switch off the power, and allow the tool to fully cool down before packing it away. Never
wrap the power lead around a tool that has not fully cooled. Any unused glue stick can remain in the
tool; it will be fully reusable when heated up again.
Application Hints
As with all adhesives, performance depends on conditions of use. Suggestions or recommendations
contained herein are for guidance only, since actual conditions of use are outside the supplier’s control.
•
Ensure that the surfaces to be bonded are dry, free from dust, grease, and loose particles.
•
Apply adhesive to one surface only. Bring the two surfaces together immediately, quickly
making any further adjustments. Hold the joint for 20 - 30 seconds to complete the bond.
•
When gluing dissimilar materials, apply the adhesive to the least heat conductive of the two.
•
On materials that are cold to the touch, a better bond can be made by pre-warming them before
applying adhesive.
•
Surplus adhesive can be trimmed using a sharp knife once it has cooled. Should molten
adhesive drip onto a smooth or polished surface, allow it to cool completely before removal.
•
Spots or blobs of adhesive are recommended for workpieces having a large surface area, or
which are particularly long.
•
Applying the adhesive in wavy lines is recommended for gluing textiles or similar materials.
•
Foam materials, like polystyrene, can be easily bonded to other surfaces. However the
adhesive must be applied to the other surfaces, not to the foam.
•
Use only genuine Loctite
®
Hysol
®
adhesive sticks to ensure reliable performance.
Loctite
®
Hysol
®
adhesive sticks are non-toxic and non-flammable.
Troubleshooting
If the stick does not advance when the trigger is pulled, check that the tool is plugged into the mains
supply and switched on. Else ensure that the tool has had sufficient time to warm up, and that “glue
backup” or “meltback” has not occurred (where molten adhesive becomes visible at the point where the
glue stick enters the heater tube) – see
Care and Maintenance
.
Care and Maintenance
•
When in use, do not lay the tool on its side - always place upright using the stand provided.
•
Do not use excessive force on the trigger. Ensure that the tool has fully warmed up before use.
•
Keep the nozzle clean to prevent adhesive build-up. This is easily done by wiping the nozzle with
clean paper or cloth whilst the nozzle is still warm.
•
Should glue “backup” or “meltback” accidentally occur, switch off the tool and allow the adhesive to
cool. Gently pull away this excess adhesive, reconnect the power, and allow the tool to warm up
again. Now squeeze the trigger two or three times to advance the glue stick, then use the tool as
normal.
Replace the nozzle if worn or damaged.
Only replace the nozzle whilst the tool is still warm.
Disconnect the tool from the power supply before proceeding, and always use protective gloves.
Unscrew the nozzle from the tool using a 1/2” (13 mm) spanner. Fit the replacement nozzle, ensuring
that it is securely tightened.
