Please Observe the Following
Safety
•
Do not touch the nozzle or molten adhesive with bare skin as they are hot - the operating
temperature of the Loctite
®
Hysol
®
050-LITE is approximately 400ºF (200ºC).
•
Protective gloves should always be worn. Careless handling can cause skin burns.
If molten
adhesive comes into contact with the skin immerse the affected area immediately in plenty of cold
water. Seek medical advice if necessary.
•
Never use the tool if it is damaged in any way.
•
Do not use this tool in damp rooms, outdoors while it is raining, or where there is high humidity.
•
Do not use this tool in the vicinity of any heat-sensitive materials, or any flammable materials, liquids,
or gases.
•
Only use extension cables that meet the specification shown in “Technical data”.
•
Never pull on the tool’s connecting cable.
Items supplied
Hot Melt Stick Dispenser
Wire Stand
Manual
Description
The Loctite
®
Hysol
®
050-LITE Hotmelt Applicator contains a new technology self-regulating heater,
providing accuracy in temperature control and excellent reliability. The tool operates on any voltage
from 100 - 240 VAC, and can be used within 7 minutes of being switched on. For total safety the heater
housing is totally enclosed, and the applicator is electrically double-insulated.
Technical Data
Dimensions (L x H x W):
8” x 6 9/16” x 1 5/16”
(approx. 210 x 170 x 36 mm)
Total weight:
3/4 lbs. (approx. 360 g)
Connection cable with mains plug:
78” long (1.8 m)
Operating voltage:
100 to 240 VAC 50/60Hz
(electronic voltage control)
Heating up time:
5 - 7 min.
Operating temperature:
approx. 400°F (200°C)
Diameter of adhesive inlet:
1/2” (12 mm)
Extension cable:
max. 65 ft long (20 m)
Wire cross section:
at least 16 a.w.g. (1.5 mm
2
)
Power consumption
Heating up phase:
approx. 500 W
Rest period:
approx. 20 W
Operating phase:
approx. 45W
Installation
Before using the tool for the first time:
1.
Check it carefully for signs of external damage. If any transit damage is found DO NOT USE
THE TOOL - return it to your supplier immediately.
2.
Attach the enclosed stand to the tool by locating the hooks on its legs into the holes on either
side of the casing. When correctly assembled the stand should pivot, snapping into two
possible positions.
3.
Insert a Loctite
®
Hysol
®
glue stick into the rear of the tool. Push the stick forward until slight
resistance is felt.
