5
YACHT ROUTER
5. SAFETY AND HAZARD
Do not operate your Yacht Router:
•
In areas where blasting is in progress.
•
Where explosive atmospheres may be present including refuelling points, fuel depots, and chemical plants.
•
Near medical equipment, life support equipment, or any equipment which may be susceptible to any form of radio interference.
In such areas, the Yacht Router
MUST BE POWERED OFF
. Otherwise, the Yacht Router can transmit signals that could interfere with this equipment.
In an aircraft, the Yacht Router
MUST BE POWERED OFF
. Otherwise, the Yacht Router can transmit signals that could interfere with various on-board systems and may be dangerous to
the operation of the aircraft or disrupt the cellular network. Use of cellular and WIFI equipment in an aircraft is illegal in some jurisdictions. Failure to observe this instruction may lead to
suspension or denial of cellular services to the offender, or legal action or both.
Some airlines may permit the use of cellular phones while the aircraft is on the ground and the door is open. The Yacht Router may be used normally at this time.
IMPORTANT: Exposure to Radio Frequency Radiation.
63 cm minimum distance has to be maintained between the antenna and the occupational user and 142 cm to general public. Under such configuration, the FCC radiation exposure limits
set forth for an population/uncontrolled environment can be satisfied.
List of approved antennas:
Omni Directional (pole), model Locomarine WIFI 5
Omni Directional (pole), model Locomarine WIFI 6
Omni Directional (pole), model Locomarine MOB 5
ANTENNA INSTALLATION:
antennas MUST NOT BE COLLOCATED within 20 cm range to each other to satisfy FCC regulations.
WARNING:
It is installer’s responsibility to ensure that when using the authorized antennas in the United States (or where FCC rules apply); only those antennas certified with the product
are used. The use of any antenna other than those certified with the product is expressly forbidden in accordance to FCC rules CFR47 part 15.204. The installer should configure the output
power level of antennas, according to country regulations and per antenna type. Professional installation is required of equipment with connectors to ensure compliance with health and
safety issues.
