C. Cut along the line between the studs with your saw. If you hit any obstructions,
stop immediately and check the cut to make sure you have not caused any
unintended damage.
D. Measure 20 7/8 inches from the bottom line upward and draw a vertical line
straight up on both sides of the bottom cut.
E. Draw a straight line that connects the tops of the two vertical lines. To ensure
that you have traced the lines at the proper distance, hold the safe up to the wall
aligned with the traced lines and the bottom cut line. The trace should be outline
the back of the safe (not including the front flange).
F. Cut along all the lines you have just traced and remove the rectangular wall
cutout that results.
G. Straighten and place the safe in the hole positioned at the height you want.
H. At each of the four holes on the sides of the safe wall, drill a hole for the bolt
anchors. Place the bolt anchors in the drilled holes and insert one bolt in each
bolt anchor, securing the safe.
5. USING YOUR SAFE
To open the safe, enter your combination code and confirm by pressing the “A”
button. You will hear a beep and the green light will light up. Within 5 seconds,
open the door using the knob.
If an incorrect combination is used 3 times consecutively, you must wait for 20
seconds before reattempting to open the safe. If again, after the 20 second wait,
an incorrect combination is entered 3 times consecutively, you must wait
approximately 5 minutes before reattempting access.
6. BATTERY REPLACEMENT WARNING
If the batteries are low, the red light (on the left) will warn you immediately upon
an access attempt. To test the batteries, simply input your combination to open
the door. If the batteries are low, the red light will light up. If there is no red light
when accessing the safe then the batteries are in good condition.
7. REPLACING THE BATTERIES
The safe requires 4 size “AA” (1.5V) batteries. Open the safe, then open the
battery cover plate (see “Y” in diagram 1) on the back of the door and replace the
old batteries. **Upon replacing the batteries you must reprogram your
combination using Step 3 above. Use of alkaline batteries is recommended.
8. OVERRIDE INSTRUCTION TO OPEN THE SAFE
Your safe comes with a manual override system. If you forget or misplace your
combination, remove the small central sticker on the front panel with the key
picture on it (see “Z” in diagram 2). Insert the key into the keyhole and turn
it counter-clockwise, then turn the knob clockwise (towards the right). This will
manually open your safe.
https://www.supplychimp.com/
Содержание LS-52-EN
Страница 3: ...https www supplychimp com...
