390/390-2 DEL
MAGNETIC LOCKING SYSTEM
6
Form 39990 Rev. E
09/23/2005
4. TEMPORARILY MOUNT TEMPLATE OR MAGNET TO MOUNTING PLATE
NO
YES
GAP
NO
GAP
Using 1/4-20 flat head screws, temporarily secure the
plastic or metal template to the mounting plate, carefully
passing the wiring through the hole in the template.
GAP
NO
GAP
NO
YES
5. ALIGN MAGNET WITH ARMATURE
With door closed and latched push magnet assembly (or template) toward the armature by applying pressure on each
end of the magnet until fully mated together, as shown below. Mark the position of the mounting plate. Remove mag-
net from the mounting plate without moving the mounting plate. (If using template, tighten two pan head screws
through holes in template before removing it.) Tighten the slotted hole screws without moving the mounting plate to
assure proper alignment.
CAUTION:
Do not press on the PC board while moving the magnet. This could cause damage.
PUSH HERE TO
CLOSE GAP
PUSH HERE TO
CLOSE GAP
Make sure that the hole
in the template lines up
with the socket cap
screw in the armature.
3/16”
