LockMaster SCG 50H, Руководство пользователя

Страница: 10 / 16

9
2). The opener must be parallel to the gate.
3). Make sure there is 1” distance at least between the chain box and the gate after you position the base
plate.
Installation of Magnets for Limit Switches
Before install limit switch, make sure the gate opener is put in manual operation. (the clutch connected with
gear shaft is disengaged) and the mains power supply is disconnected.
Position the two Magnet Components approximately on the gate and move the gate by hand to fix them in
place.
Fit magnets bracket
Push the gate fully closed by hand.
Locate and install the magnet bracket
so that the opener will stop at the
desired close position when the close
limit switch approaches it.
Push the gate fully open by hand.
Locate and install the magnet bracket
so that the opener will stop at the
desired open position when the open
limit switch approaches it.
The higher magnet component
must be installed at left side and
lower magnet component must be
installed at right side from the view
inside of property.
Finally adjust the
magnet to the proper position by
moving the gate with the motor. The
magnet should be .39 - .59 “away from the magnetic limit switch. If it is too far away, the switch will fail to
work. The distance between the magnet and the opener should be 1/2” (12mm) with the opener cover on.
Adjust the position of the magnet until the positions of the opening and closing meet the requirement.