LNS QUICK LOAD SERVO S3 T BARFEED, Руководство по обслуживанию

Страница: 11 / 152

PROCEDURES
SERVICE MANUAL – QL Servo S3-T
2. PROCEDURES
SETUP, ALIGNMENT, AND ANCHOR PROCEDURE
INFORMATION
The following conditions must be met to complete this procedure:
•
Bar feeder power off
• No pneumatic pressure
Reminders:
•
To obtain a perfect alignment, it is advisable to install the largest feeding pusher.
•
If a spindle liner is installed, make sure that its I.D. is larger than the O.D. of the feeding pusher.
• It is not mandatory that the lateral level of the bar feed system is perfect; just make sure that the latter is as straight as
possible.
•
The longitudinal level of the bar feed system must be adjusted according to the level of the lathe, even if the lathe lies
only over three points and cannot be perfectly levelled.
Should the level of the bar feed system not correspond to that of the lathe, the feeding pusher might touch the inside
of the spindle.
Place the bar feeder as close as possible behind the headstock lathe. The distance between the front of bar feeder and the
back of headstock lathe should be as small as possible.
Before proceeding with the alignment of the bar feed system, ensure that the lathe is stable and levelled.
1. Position the bar feed as close as possible to the rear of the lathe. The distance between the front
of the bar feed and the back of the spindle should be as small as possible.
Note :
If obstacles prevent the bar feed from being positioned within 8 inches of the back of the spindle an
extension will be required.