LNS GT 112-E, Инструкция по эксплуатации

Страница: 78 / 201

Chapter 8 OPERATION
8 - 3
GT 112-E
Open Channel
The key offers three functions :
1. When pusher is at home position and bar feeder is in
in
MANUAL
mode
,
pressing this key will automatically start the
following sequencing:

The long pusher moves forward to extraction position
(behind the vise).

The vise closes to check remnant disposal. Then after
the long pusher returns to its home position.

The guiding channel opens.
2. If the pusher exceeds the position “1
ST
FEED LOADING
FLAG P 150mm”, the channel will open when
pressing this key.
3. Loading a bar from the magazine into the channel
When the channel is open, pressing this key again the bar
measuring device will set in the ready position (up).
Close Guiding Channel
This key offers two functions :
1. When the pusher is at a position shorter than the First Feed
position and the bar feeder is in
MANUAL
mode
,
pressing this
key will automatically start the following sequencing:

The loading flag moves forward to the First Feed
position.

The short pusher returns to its home position.

The guiding channel closes and the long pusher
advances for bar insertion. (If there’s no bar, the bar
feeder will not cycle an insertion.)
1. If the channel is opened by pressing when the long
pusher is at a position exceeding “1
ST
FEED LOADING
FLAG P 150mm” and the chuck of the lathe open
the guiding channel will close when pressing .