LNS GT 112-E, Инструкция по эксплуатации

Страница: 103 / 201

8 - 28
Chapter 8 OPERATION
GT 112-E
Defines the condition of R2 signal at End of Bar.
1 R2 signal will be OFF during End of Bar condition.
2 R2 signal will be ON during End of Bar condition.
＊
Refer to the timing chart <3> on 8.6.2.1
15 R2 ON at top cut position (Refer to INTERFACE13, 14, 16 for related setup)
Defines how long R2 signal remains On from the time
the new bar stock reached the Top Cut position.
1 R2 signal remains ON until the chuck of the lathe
closes.
2 R2 signal is pulsed for 2 seconds.
＊
Refer to the timing chart <3> on 8.6.2.1
16 R2 to confirm (Refer to INTERFACE13, 14, 15 for related setup)
Defines R2 signal functionality.
1 R2 signal turns ON to confirm the newly loaded bar
reaches Top Cut position.
2 R2 signal turns ON to confirm the newly loaded bar
reaches the Top Cut position and also to confirm part
feedout when M-code is connected.
＊
Refer to the timing chart <3> on 8.6.2.1
17 R3 signal latches at End of Bar
(Refer to INTERFACE18, 19, 20, 31, 32, 33 for related setup)
Defines the type of R3 signal output.
1 R3 signal turns ON when the pusher reaches the End
of Bar position and remains ON. It turns OFF
according to INTERFACE18, 19, 20 or 33 setup.
2 R3 signal turns ON only while the pusher is in the End
Of Bar position.