7 (8)
Assembly instructions | LK Wallbox UNI Push AX16 V2 and AX20
EN.29.C.46.20200318
3.5. Attach the bracket to the plate with the screws
included.
3.6. Continue installing the box according to step 1.4.
LK Wall Support Wallbox UNI Push 150 N5
When two wallboxes are to be installed in a woo-
den stud framing, LK Wall Support Wallbox UNI
Push 150 N5 (Article no. 188 22 95) can be used.
The wall support is for mixers with c/c 150 mm
and is suitable for walls that have maximum 600
mm distance between the studs.
NOTE!
It is c/c 75 mm between the holes on the
wall support, but there are no collars for this
assembly.
4.1. Attach each wallbox to the plate with four of
the included system screws as shown above.
4.2. The stud must be jacked out 8 mm deep on top
edge to provide space for the plate reinforcement
edge.
4.3. Attach the plate to the stud using the four
countersunk wood screws included.
4.4. Continue to mount the wallbox according to
step 1.4.
LK Wallbox UNI Push Clamp
When the wallbox is to be installed from the back
then it is easier to use
LK Wallbox UNI Push
Clamp
(Article no. 188 11 04). The clamp means
the screw is attached at a slight distance from the
wallbox.
5.1. Mount the wallbox in the hole (Ø 54 mm),
mount the clamp. Attach the clamp and the wall-
box using four screws (not included).