- 7 -
Freedom Trax FT1 users manuel
may 2018
ADJUSTMENT/SET UP
Please note that you should never attempt to adjust the device while a wheelchair is mounted. If
Freedom Trax™ is not properly aligned, dismount the wheelchair and make adjustments while it
is not attached to a wheelchair.
Freedom Trax adjusts in the middle by loosening (2) 5/16” bolts with a ¼” allen wrench
located on framing cross members. The thumb screws on the back motor support must
also be loosened to allow the device to adjust.
To narrow or widen the device, pull or push the front and rear of the frame back and
forth until the rear wheel cradle aligns with the measurement of the wheelchair.
Depending on the model of wheelchair, narrowing the rear wheel cradles by ¼” from the
wheelchair allows for easier mounting. For a proper fit, ensure that the rear wheel
cradles are parallel or an equal distance apart from the front to the rear of the cradles.
After adjustment, ensure that the front and rear cross brace lock mechanisms are
tightened back by hand.
The front caster cradle is not adjustable. It is designed to accommodate a range of front
caster orientations. If the wheelchair cannot fit within the parameters of the device,
contact us immediately and we can determine if modification is necessary to properly fit
the wheelchair. To maintain the front ramp/mounting assembly in proper working order,
always make sure no debris is left in the front caster cradle after use.
The front safety strap is essential to prevent the front mounting ramp from lowering
during operation. The front strap is adjustable in length and can be secured to any
convenient location on the wheelchair.
The back wheel stop must be adjusted and tightened prior to operation. The back stop
should be set to allow the wheels to rest against the backstop when the front caster is
securely fastened in the front caster cradle.
TENSIONER ADJUSTMENT
Over time, the tensioner will require adjustment as the track expands due to wear. To
adjust the tension limiter, remove the track and adjust the 3/8” nut at the base of the
spring. The track is set to the correct tension limit when the track can only depress by
.500” from top to bottom.
