4796/4
79
7
SEDONA TWIN/
TWIN LOFT BUNK
w/ 2 DESKS
PARTS LIST:
A)
24 -4 1/4" Lag Bolts
B)
24 -Black Steel Washers
C)
2 -End Assemblies
D)
2 -5 1/4" x 75" Mattress Rails w/Support Cleats
E)
4 -3 1/4" x 75" Guard Rails
F)
3 -3 1/2" x 38
3/4
" Mattress Supports
G)
1
0
-1 1/4" Black Flat Head Wood Screws
H)
6
-Angle Brackets
I)
24
-3/4" Round Head Screws
J)
2 -Modular Roundup Case Ends (Desk or Chest)
TOOLS REQUIRED:
1)
7/16" Wrench or Socket Wrench
2)
Phillips Head Screwdriver
Mak
e you have all parts before beginning assembly. If you need a part, contact
Living Spaces.
1)
Attach two mattress rails(D) and
four
guardrails(E) to end assemblies(C) with 24 lag bolts and 24 washers,
and tighten.
2)
Place modular case ends(
J
) as pictured on
page 3
, with an overall width of approximately 84". Place
completed top bed assembly
on the
modular
ends. There should be about 3" of each modular end top
extending beyond the bed assembly at each end.
3)
Attach the bed assembly to the modular ends with the 6 L brackets and 24 round head screws. See diagram
on page 3 for location suggestion.
4)
Roll out Slat Kit and stretch from bed end to bed end. Secure with 4 wood screws, in each end of the two
outermost slats, one in each corner of the bed. Center 3 individual slats in the 3 built in gaps of the slat kit,
and secure with 6 wood screws in the ends of each individual slat.
5)
Attach ladder to middle rail on top bed assembly (lower guard rail (E))
6)
Add mattress not thicker than 10" and sleep well!
Recommended: Electric driver with 7/16” socket
A FOUNDATION IS REQUIRED WITH 3 SLAT CONFIGURATION
