Living & Co TWL-CF418L, Руководство пользователя

Страница: 10 / 20

10
• Read the manual: Before installing your new freezer, read all safety instructions,
especially the sections on installation and electrical safety on page
6
. Then follow the
installation instructions below and on the next page.
• Clean: Make sure the freezer is disconnected from power supply before cleaning the
interior surfaces and all internal accessories with lukewarm water, a soft cloth and a
neutral/mild soap/detergent. This will remove any dust from transit and storage and
help remove the typical smell of a brand new product. Then dry thoroughly. Important:
Do not use harsh or abrasive detergents or powders as these will damage the finish.
3.2 Installation
3.2.1 Location
Install the appliance in an area that meets the following requirements:
• Ambient temperature: The ambient temperatures must correspond to the climate
class (T) indicated on the rating plate of the appliance: 16°C - 43°C.
• Floor surface:
The floor must be sturdy, level and strong enough to support the unit
when it is fully loaded.
• Areas to avoid: Avoid areas where the appliance would be exposed to direct sunlight,
sources of heat (stove, heater, radiator, etc.), extreme cold ambient temperatures or
excessive moisture and high humidity. Installing it in the coolest area of the room will
save energy consumption and running costs.
4. Use
4.1 Space Requirements
• Clearances: Ensure that air can circulate freely around the back of the cabinet,
which is necessary to cool the compressor and condenser. Allow at least 10cm clear
space at the back and the sides of the unit.
• Overhanging wall units: Ideally, the appliance should not be positioned below
overhanging wall units. However, if the appliance must be positioned below an
overhanging wall unit, make sure to allow sufficient room so you can comfortably
open the lid and access the contents.
4.2 Electrical Connection
• WARNING! It must be possible to disconnect the appliance from the mains power
supply; the plug must therefore be easily accessible after installation.
• Before plugging in your new freezer, let it stand upright for at least 4 hours.
This will allow the refrigerant gases to settle into the compressor and reduce the
possibility of a malfunction in the cooling system.
•
When first starting up, and after a period out of use, allow the unit to cool down
on the MAX setting for at least 2 hours before placing food in the freezer.
• The appliance must be earthed. The plug of the power supply cord is equipped with
a contact for this purpose. Do not under any circumstances cut or remove the third
(earth) prong from the power cord. If the plug does not fit your outlet, consult a
licensed electrician for advice to have the outlet changed.
• Pug the unit into a dedicated, properly earthed wall outlet. Ensure that your outlet
voltage and circuit frequency correspond to the voltage stated on the rating label.
20.indd 10 HS 384CN and HS 185CN Chest Freezer IM cv 09 07 2020.indd 1 15/07/2020 5:47:02 pm