1) Prepare wires:
Take the wire and cut it into 4" pieces. Strip the wire insulation
approximately 1/8" from each end to expose the copper. Repeat this until you have 10
pieces.
.
2) Populate Fader
Capacitors (
.01uf Capacitor):
On the Omni Board locate
SC1-4 & SC5-8
on the bottom of the board (SC denotes “single
capacitor
”). The capacitors are
bidirectional, meaning you can place them without having to worry about a positive or
negative side. Solder the single
capacitors
in positions
SC1-4 & SC5-8
. Clip off the excess
capacitor leads from the top of the board. The single
capacitors
allow the faders to
function, so if you have trouble with your faders later on it could mean a
capacitor
is
incorrectly soldered.
