Technologies , Inc
.
Technologies , Inc
.
Fiber Checker
Page 6 of 8
2009Y VER A
Liverage Technology Inc.
3F-3, No. 30 Taiyuan Street, Chupei City, Hsinchu County 302, Taiwan
TEL:+886-3-5525268 FAX: +886-3-5525388
http://www.liverage.com.tw
E-mail: [email protected]
Copyright 2009
,Liverage Technology Inc. reserves the right to modify specifications without prior notice
The breaks or
defects in the fiber.
4. Switch to CW / Pulse Mode.
5. Press the Button and check those breaks or defects in the fiber will
refract the light, creating a bright glow around the faulty area. ( Shown
as below
Illustration 1
)
Illustration 1.
6. When the LED is RED, this means that batteries are almost drained
out and in low voltage status and you will need to replace the
batteries right away.
7. Do not touch the fiber’s interface to avoid dirt into the connector.
8. Keep the fiber connector capped at all the time when the device is not
in use.
9. With proper cleaning tools to clean the fiber before testing so that to
obtain the right tests results and make the service longer.
4. Maintenance
This tool requires no maintenance other than periodic battery charges. Like
any other electronic equipment, this tool should be kept away from water, high
damp, dust, electricity, and environments of extreme temperature.
And the
internal Fiber Checker there is a fiber stub needed to be cleaned by
specific cleaning tools regularly
( Shown as
Illustration 2. )
. Please do not
drop this tool on hard surface. Modifying internally any of this tool components
can cause a malfunction and will invalid the manufacturer’s warranty.
Illustration 2.
Fiber Stub Cleaning
