LIVARNO 1020-B, Руководство по эксплуатации

Страница: 11 / 53

11
GB
tighten the star knob again�
„
Loosen the Spotlight star knob
9
to adjust
the angle (see Fig� H)�
„
When the desired position is obtained,
tighten the star knob again� If necessary,
use a screwdriver to hold the screw while
tightening the star knob�
Please note: the motion sensor has a field
of view of up to 120°� Make sure that the
motion sensor faces directly towards the
desired detection zone�
Please note: to ensure the solar panel
functions as effectively as possible, make
sure that the surface of the solar panel
2
is
not dirty�
Orientation:
The optimum alignment is facing south�
Choose an orientation facing slightly to the
west rather than slightly to the east�
z
Charging the battery
„
The battery is charged in all operating
modes� To optimise initial charging, charge
the product while it is turned off�
Please note: the battery is fully charged
after it has been well exposed to sunlight for
7 to 8 hours� The duration of the charging
process depends on the battery‘s charge
level and the quality of the sunlight�
z
Operation
The product can be operated in three
different modes� The operating mode is set
by means of the switch
5
�
Please note: the solar panel will turn on the
product in twilight or darkness in the mode
you have set�
Please note: battery charging via the solar
panel does not depend on which mode is
selected� The battery is charged continuously
at all times�
Mode 1
„
Press and hold the switch
5
for 3 seconds
to switch to “Mode 1”�
„
The Spotlight will light up once and then
switch to guide-light function (reduced
brightness)�
„
If the motion sensor detects movement
within its range, the Spotlight will light up
at maximum brightness�
„
After approx� 15 seconds, it switches back
to guide-light function�
Mode 2
„
Press the switch
5
again to switch to
“Mode 2”�
„
The light will flicker twice and then switch
off�
„
If the motion sensor detects movement
within its range, the Spotlight will light up
at maximum brightness�
„
After approx� 15 seconds, it will switch off
again�
Mode 3
„
Press the switch
5
again to switch to
“Mode 3”�
„
The light will flicker 3 times. The guide-light
function (reduced brightness) is then
permanently active� The motion sensor is
inactive in this mode�
Switching off the Spotlight
„
To switch off the Spotlight, press the switch
5
for a fourth time�
z
Troubleshooting
= Fault
= Cause
= Solution
= The product fails to switch on�
= The product is switched off�
= Press the switch
5
to turn on the
product (see section “Operation”)�