LIVARNO LUX LED ROPE LIGHT, Инструкция по сборке, эксплуатации и безопасности

Страница: 10 / 13

10 GB
Safety / Initial use
appliance contains no parts which may be ser-
viced by the consumer.
Make sure before use that the available supply
voltage corresponds to the required operating
voltage of the item (220–240 Volt ∼).
Never allow the live power leads and contacts
to come into contact with water or other liquids.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
Do not install the lamp on damp or conductive
surfaces.
This LED strip must not be connected electroni-
cally with other LED strips.
Protect the product from sharp edges, mechani-
cal loads and hot surfaces.
Do not secure with sharp staples or nails.
Always unplug the mains plug from the socket
before assembly, disassembly or cleaning.
Never catch hold of the mains plug or the LED
strip with wet hands.
Only use the individual parts supplied, other-
wise all warranty claims will become invalid.
This item must not be connected with the power
supply while it is still in its packaging provided
that the packaging has not been adjusted for
exhibition purposes. Lay out the item completely
before you connect it to the power supply.
Prevent fire and injury
hazards
This product does not contain any parts that
can be serviced by the user. The LEDs cannot
be replaced.
If the LEDs cease to function at the end of their
operational life, the entire item must be replaced.
The installed LEDs are not suitable for dimmers
or electronic switches.
Do not look into the LED from a close distance
during operation.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
Safe working
Do not leave the LED strip or packaging mate-
rial lying unattended. The packaging material
presents a suffocation hazard and there is a
risk of loss of life from strangulation.
Install the light so that it is protected from dirt
and excessive heating.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never use the LED strip if you are having diffi-
culty concentrating or do not feel well.
Before use, familiarise yourself with all the in-
structions and diagrams in these instructions, as
well as with the LED strip itself.
To completely disconnect the LED strip from
the power supply, the mains adapter must be
removed from the mains socket.
initial use
Remove all packaging materials before first
use.
The chain of lights should not be connected to
the mains supply while it is still in its packaging.
Trimming / connecting
the LED tape
The LED tape may be trimmed to size or connected.
DANGEr To LiFE BY ELEc-
Tric ShocK! Disconnect the lights from the power
supply before performing any work on the LED strip
3
. Remove the mains plug
1
from the mains
socket.
Choose the desired LED strip length.
Note Ensure that you cut the LED strip at the
right place. The cutting point lies exactly between
the plus and minus pole and is marked with a
black line (Fig. B).
Shorten the LED strip
3
using a pair of scissors.
Then press both ends of the LED strip
3
onto
the displacement contact of the plug connec-
tion
4
(see Fig. C).
... / Installing the ... / Maintenance and Cleaning / Disposal / Warranty and Service