LIVARNO LUX 91168, Руководство пользователя и сервисная информация

Страница: 32 / 38

Magnifier Lamp LLL 90 A2
30 - English
Now fit the entire lamp body (A) down into the hole in the fixing pin (D). This means that the outlet
opening for the mains cable and the wing screw (C) you undid earlier must be on top of one another.
Now tighten the wing screw as far as it will go. The lamp is now fixed in its current position and secured
against accidental twisting or removal from the holder. If you release the wing screw (C) a whole turn
anticlockwise, you can adjust the lamp body (A) by around 65° to the left or around 65° to the right to
suit your requirements. The lamp is still fixed in its current position and secured against accidental twisting
or removal from the holder. If you undo the wing screw (C) another 5 to 6 turns anticlockwise, you can
rotate the lamp body (A) about 360°. Please note that, in this case, the lamp is no longer secured against
accidental removal from the lamp holder.
Getting Started
Switching the magnifier lamp on and off
Note on mains disconnection:
The magnifier lamp is only disconnected from the mains when the mains plug is
removed from the socket. Switching off the magnifier lamp using the On/Off switch
does not disconnect it from the mains supply.

Insert the mains plug into a suitable mains socket. Do not use an extension cable or socket strip if
it does not comply with the relevant safety regulations.

Switch the On/Off switch (1) to the "I" position to switch the magnifier lamp on.

Switch the On/Off switch (1) to the "0" position to switch the magnifier lamp off.
Aligning the magnifier lamp
Using the ball joint (2) on the lamp shade and the rotating arms (4) you can easily adjust the lamp to suit
your needs.
Thanks to the rotatable joint (3) it is possible to rotate the lamp head approx. 270°. The joint is fixed with
the corresponding clamp screw.
Please untighten the clamp screw slightly before adjusting the lamp head on the rotatable joint.