14 GB/IE
Safety / Start-up
Avoid the risk of fatal injury
from electric shock
Check the light for damage every time before
you use it. Never use the light if it shows any
signs of damage.
A damaged light means danger of death from
electric shock. In the event of damage, repairs
or other problems with the light please contact
the service centre or a qualified electrician.
To prevent hazards, a damaged flexible outer
lead on this lamp must be replaced by the man-
ufacturer, its service representative or an equally
qualified professional!
Before use, verify the available mains voltage
corresponds with the operating voltage of the
lamp (see “Technical data”).
The lamp's illuminant is not replaceable. The
entire lamp needs to be replaced if the illumi-
nant reaches the end of its service life.
Ensure that the light does not come into contact
with water or other liquids under any circum-
stances.
Always disconnect the plug-in transformer
4
from the mains prior to assembly, disassembly,
cleaning, or if the light will not be used for
extended periods.
Never open any of the components of the elec-
trical equipment or insert any objects into the
same components. This will pose a risk of fatal
injury from electric shock.
The light bulb is not suitable for ex-
ternal dimmers or electronic switches.
Never use the power cable
5
to carry the
device.
Do not kink the power cable
5
or run it over
sharp edges.
Prevent fire and
injury hazards
RISK OF INJURY!
Check every illuminant for damage immediately
upon unpacking. Do not install the light if the
illuminants are defective. In this case contact
the service centre for a replacement.
Do not look directly into the light source (light
bulb, LED etc.).
Do not cover the lamp or the plug-in trans-
former
4
with objects. Excessive heat build-up
can result in fire.
Never leave the lamp unattended whilst in use.
Do not look at the LED with an optical instru-
ment (e.g. magnifier).
Safe working
Mount the light so that it is protected from
moisture and dirt.
Carefully prepare for assembly and allow your-
self adequate time. Organise all parts and any
necessary additional tools or materials before
starting so they are easy to reach.
Always be attentive! Always pay attention to
what you are doing and use common sense.
Never assemble the lamp if you are unfocused
or feel unwell.
In order to completely disconnect the light com-
pletely from the power supply, the plug-in trans-
former
4
must be removed from the socket.
Start-up
Carefully remove the parts of the lamp from the
packaging.
Remove all protective material.
Insert the lower lamp arm
3
into the mounting
provided so that the pin
9
is seated in the
slot
10
. Be careful not to damage the lamp arm.
To fasten the lower lamp arm
3
, tighten the
screw
11
slightly.
Connect the plug-in transformer
4
to the lamp
base
6
.
Plug the plug-in transformer
4
into a socket
that has been professionally installed.
Your lamp is now ready to use.
Start-up / Maintenance and cleaning / Disposal / Information
