LIVARNO LUX 284921, Инструкция по сборке, эксплуатации и безопасности

Страница: 8 / 43

8 GB/IE/NI
burns on contact with the skin. Wear suitable
protective gloves at all times if such an event
occurs.
This product has a built-in rechargeable battery
which cannot be replaced by the user. The
removal or replacement of the rechargeable
battery may only be carried out by the manu-
facturer or his customer service or by a similarly
qualified person in order to avoid hazards.
When disposing of the product, it should be
noted that this product contains a rechargea-
ble battery.
Functioning
When exposed to sunlight, the solar cell
12
converts
the light into electrical energy and via the connected
solar electricity socket
8
, stores the electricity in
the built-in rechargeable battery. With a fully
charged rechargeable battery, the lighting duration
is about 1.3 hours. Before being used for the first
time, the rechargeable battery must be fully loaded
(see section “Charging the rechargeable battery”).
Charging the
rechargeable battery
Upon delivery, the rechargeable battery is fully
charged. Due to storage times, the rechargeable
battery may be partially discharged when first
used. Therefore, charge the rechargeable battery
completely before first use.
Charging the rechargeable batteries with
a solar cell
Toggle the ON / OFF switch
11
into the OFF
position, so the charging process is not influ-
enced by the light being switched on.
Insert the solar cable plug
14
into the solar
electricity socket
8
of the spotlight
10
. Posi-
tion the solar cell
12
as described in section
“Mounting the solar cell
12
”.
Note: With steady exposure to sunlight, the
rechargeable battery is fully charged after 4 to
6 days. The duration of the charging process
depends on the charge state of the rechargea-
ble battery as well as the quality of the expo-
sure to sunlight.
Assembly
Note: Remove all packaging materials from the
product.
Before mounting, decide where you want to Mount
the solar cell
12
and the spotlight
10
. The solar
cell
12
and the spotlight
10
can be mounted inde-
pendently of each other, but after being mounted
must be connected with the approx. 3 m long
power cable of the solar cell
12
. After the mount-
ing, lay the cable so it is not subject to any me-
chanical stresses. Use typical installation material
such as cable clamps or conduit to fasten the
cable, to prevent damage to the insulation.
Note: The included mounting material is suitable
for ordinary solid concrete or masonry construc-
tion. Other wall substrates may require other fasten-
ing materials. Seek specialist advice if necessary.
Mounting the spotlight
Make sure you will not be drilling into electrical,
gas or water lines inside the wall. Use a power drill
to drill the holes into the brick wall. Always observe
all safety instructions for the power drill in the ma-
nual for the power drill. Death or injury due to elec-
tric shock may otherwise result.
When selecting the mounting location for the
spotlight
10
, pay attention to the following:
Make sure the spotlight
10
illuminates the
desired area. You can move the spotlight
10
.
Make sure the motion detector
9
covers the
desired area. The motion detector
9
has a
maximum coverage range of 12 m, with a cov-
erage angle of about 180° (depending on the
mounting height – a height of 1.8–2.5 m is
ideal) .
Make sure the motion detector
9
is not illumi-
nated at night by street lighting. This can
influence its functioning.