LIVARNO LUX 113907, Инструкции по эксплуатации и безопасности

Страница: 8 / 45

8 GB
Safety / Preparing the product for use
components and additional tools or materials
required so that you can see and reach them.
Remain alert at all times and always watch what
you are doing. Always proceed with caution
and do not assemble the lamp if you cannot
concentrate or feel unwell.
Preparing the product for use
Assembling the lamp
Note: You will require a second person to help
with the assembly of the product.
Note: Be sure to pull the cable through the base
even and slow
13
during assembly.
Before installation, remove the two black plastic
rings on the end of the support tube
18
to allow
the components to be screwed together properly.
Note: Ensure that the mains lead does not be-
come trapped when it is fed through the sup-
port tubes
18
,
21
.
First screw the support tube
18
clockwise into
the upper support tube
21
.
Then screw the support tube
10
clockwise into
the flexible arm
5
.
Note: Ensure that the threaded rods
17
are
screwed in as far as possible so that the lamp
is stable when standing up.
Screw the two threaded rods
17
clockwise into
the support tubes
10
,
18
and push the support
tube mount
16
on to the threaded rods
17
.
Insert the floor lamp with the threaded rods
17
into the preformed holes in the base
13
.
Place the serrated lock washers
14
at the
underside of the support tube
13
on to the
threaded rods
17
. Using the open spanner,
tighten the nuts
15
clockwise on to the threaded
rods
17
to fix the floor lamp to the base
13
.
Note: Ensure that you hold the support tubes
10
,
18
and threaded rods
17
firmly in place
when you are tightening the nuts
15
.
Glass torchiere:
Slide the lamp glass
3
over the socket
4
.
Secure the glass with the threaded ring
2
(screw on clockwise).
Glass reading light:
Slide the lamp glass
7
over the socket
6
.
Then slide the silicone ring
8a
over the socket
6
.
Secure the lamp glass
7
and silicone ring
8a
with threaded ring
8b
and tool
9
(screw on
clockwise).
Note: Use a dry, fluff-free cloth for inserting
the bulbs.
Screw the bulbs
1
,
11
clockwise into the
fittings
4
,
6
.
Insert the mains plug
12
into a properly
installed socket.
Your lamp is now ready for operation.
Switching the lamp on / off
Use the ON / OFF switch
20
to switch the
uplight on or off.
Use the ON / OFF switch
19
to switch the
reading lamp on or off.
Directing the lamp
CAUTION! RISK OF BURNS! First allow
the lamp to cool completely.
Bend the flexible arm
5
to bring the reading
lamp into the desired position.
Replacing a bulb
RISK OF ELECTRIC SHOCK!
First pull the mains plug
12
out of the mains socket.
CAUTION! RISK OF BURNS! First allow the
lamp to cool completely.
Note: Use a dry, fluff-free cloth for inserting the
bulbs.
Unscrew the defective bulb
1
,
11
anticlockwise
out of the fitting
4
,
6
.