9
LITTLE
WONDER
PRO VAC SP
SET-UP INSTRUCTIONS
UNPACKING THE UNIT
1. Remove uprights from box.
2. Lift box off pallet.
3. Cut off tiedowns.
4. Roll VAC off of the pallet.
ASSEMBLY (See Figures on page 10)
1. Install the
band clamp
into the
debris bag
(wear
gloves when handling band clamp):
•Slide the bracket end of the band clamp through the
left side opening of the sleeve on the debris bag
until it emerges from the right side.
•Feed the tail end of the band (on the clasp side)
behind the bracket in the sleeve.
•Pinch the wire form on the clasp together and
connect it through two holes in the adjustment
bracket such that it will close tightly over the
collector.
2. Connect the
debris bag
by placing it over the bottom
lip of the
collector
and closing the clasp to secure the
bag. Adjust the clasp wire form to the appropriate hole
position on the bracket to ensure a tight fit. If the bag
will not fit tight within the range of the three adjustment
holes, insert the bag
seal strap
:
•Unhook the wire form from the bracket.
•Pull the tail end of the band back out from behind
the bracket.
•Feed one end of the
seal strap
behind the metal
band and through the channel to the other side.
•Tuck the other end of the
seal strap
behind the
bracket (overlapping the lead end of the
seal strap
).
•Feed the tail end of the
band clamp
behind the
bracket (overlap the
seal strap
).
•Connect the wire form to the appropriate holes in the
bracket and secure the debris bag to the collector.
3. Attach
nozzle assembly
to base unit:
•Attach one end of the
hose
to the nozzle assembly
with the
bridge clamp.
•Slide the other end of the
hose
over the edge of the
inlet on the
front plate.
•Remove cotter pins from front sheel bracket. Hook
one side of the
nozzle bracket
over the front axle.
•Bend the other end of the nozzle bracket inward
to hook it over the axle and the pins on the
wheel
bracket
with the slots on the
nozzle bracket.
Reinsert the
cotter pins.
•Secure the hose to
front plate
inlet with the
bridge
clamp.
•Attach the
nozzle cable
end fitting through the hole
in the
nozzle bracket.
4. To remove
nozzle assembly
(for purposes of storage,
or clearing blockages):
•Turn engine off and disconnect spark plug.
•Loosen
hose clamp
on the
front plate
with flathead
screwdriver or 5/16 wrench.
•Slide hose off of
front plate
inlet.
•Remove the
cotter pins
on the front wheel bracket.
Bend one side of
nozzle bracket
inward and twist
the
assembly
to remove the hook from the axle.
•Twist back and lift to remove the other side of
nozzle bracket
from the axle. Re insert the
cotter
pins
on the front wheel bracket.
LIFTING LUG
The Little Wonder PRO Vac includes a convenient lifting
lug
A
on top of the fan housing that can be used to lift the
unit.
