III. Adjusting the height of the ladder for use in the A-Frame position.
A.
Safety straps are only on the aluminum SkyScraper models.
1. With the ladder in the closed storage position; lay the ladder flat on an
unobstructed surface. (See figure C-1)
2. Pull the two top Lock Tabs out of the rung holes of the inner ladder
and rest them on the side of the outer ladder rail. (See figures C-2 and C-3)
3. Telescope the top outer unit to desired length. (See figure C-4)
4. Return the two Lock Tabs back into the rung holes of the inner ladder sections.
Check to make sure they are fully engaged. (See figure C-2)
5. Flip the ladder over and place the extended
outer unit on flat surface. (See figure C-5)
Figure C-1
Lock Tabs
Hinge Locks
Figure C-2
Figure C-3
Figure C-4
Figure C-5
6. Repeat steps 2 through 4.
7. To raise the ladder, unlock the hinge locks, brace the feet against the wall
and walk the ladder (rung by rung) to a vertical position. (See figures
C-6
and C-7)
8. Open the ladder to the A-frame configuration by pulling the ladder halves
apart until the hinges lock into place.
Figure
C-6
Figure C-7
9. To return the ladder to storage position:
a. In the A-Frame position tip ladder to
the side and lower to a flat surface.
b.
Unlock
both hinges and bring the
ladder halves together.
c. Rotate the ladder and place it
flat on surface.
d. Reverse the procedures of steps
C-1 through C-5.
B.
Adjusting the ladder in the staircase
position.
1. Adjust the ladder to desired height. (See steps
C-1 through C-5)
2. Then adjust the desired side for proper
alignment to fit the staircase (See figure D-1).
CA
U
TION:
HEED THE WARNING ABOVE EACH LOCK ASSEMBLY.
Figure D-1
©2011 Little Giant Ladder Systems 50114 v1 7.11
WARNING:
DO NOT
USE
LADDER WITH DAMAGED OR REMOVED SAFETY
STRAPS. F
AILURE
TO HEED WARNING MAY
RESU
LT IN
INJU
RY.
ENGAGE ALL FOUR
LOCK TABS INTO THE
RUNGS TUBES OF THE
INNER LADDER BEFORE
CLIMBING
