background image

Rev: 081718

© 2018 Littelfuse Commercial Vehicle Products 

littelfuse.com 

2 of 3

Installation Instructions
MiniFlec Series Power Distribution Module

Part Number: LFMX0007Z-01

Specifications, descriptions and illustrative material in this literature are as accurate as known at the time of publication,  

but are subject to changes without notice. Visit littelfuse.com for the most up-to-date technical information.

Figure 1 - Step by Step Installation 

Mounting Pattern Diagram

65mm

55mm

133mm

157mm

STEP 

1

IMAGE

DETAILS

Cut the panel per the mounting hole pattern and 

place the mounting bolts into the locations on the 

panel.

STEP 

2

IMAGE

DETAILS

Take the unit out of the packaging. Snap open 

the AssureLatch latches with a small flathead 

screwdriver or other tool. Remove the cover.

STEP 

3

IMAGE

DETAILS

Fill in all fuse locations with application specific 

fuses make sure not to exceed the maximum value 

for the fuse locations as listed in fuse table. Fill the 

application specific relays using the recommended 

types of relays. There is a location on the inside 

cover to place a fuse identification label. We 

recommend you add a label here to help with 

maitenance and troubleshooting. Replace the cover 

and snap on the AssureLatch latches. If you do not 

get positive tactile and audible feedback that the 

latches are fully seated, check the position of the 

cover. The box is only seated correctly and sealed 

when laches are properly snapped into place. 

STEP 

4

IMAGE

DETAILS

Bring the main power cable through the cutout 

and attach the ring terminal to the main M8 power 

stud. Run the harness with the connectors through 

the mounting hole and attach the connectors to 

the appropriate point. All the connectors are keyed 

and cannot be assembled to an incorrect location. 

Press the connectors into the mating connector 

locations and make sure they are fully seated and 

the secondary lock is closed.

STEP 

5

IMAGE

DETAILS

Put the MiniFlec into the cut out and tighten the 

mounting bolts to 12-15Nm.

Отзывы: