Lithium Grim The Senator, Инструкция по сборке

Страница: 8 / 12

The Senator v1.0
Manufacturers and product names are mentioned solely for circuit identification, and where applicable their trademarks are the
property of their respective owners who are in no way associated or affiliated with the author. No cooperation or endorsement
is implied.
8
Switches
The PCB was designed so that 3 single pole switches will fit easily in the enclosure. There is a special
gap made in the PCB which will fit almost all types of miniature single pole switches. There are a lot
of configurations possible, and you are free to experiment. By default you can use this configuration:
In this configuration, SW2 (caps) is not installed. You could use a small internal SP3DT switch (ON-
OFF-ON), make a 3pin header with a shunt like in the picture or hardwire it. There are other
configurations possible like this one:
Note that there is little room between the potentiometers and when trying to fit a DP3T between
them you cannot use the optional plastic cases on the potentiometers. Fit before you decide!
There are different types of DP3T On-Z-On switches. Check which contacts connect in the middle
position and change the wiring if it is not to your liking!
Switch in middle position
Variac 1 SPDT
(On-On)
Variac 2 SPDT
(On-On)
Push SPDT
(On-On)
<- on off ->
Variac DP3T
(On-Z-On)
Caps SP3T
(On-Off-On)
Push SPDT
(On-On)
<- on off ->
1
2
3
6
5
4