Lithium Grim Snail Gear, Инструкция по сборке

Страница: 7 / 9

Snail Gear v1.1
7
Biasing
The most important part of this build is the biasing. If your effect is inaudible at low attack settings
then it is not biased correctly. Biasing can be done by ear, but can be difficult, so take your time.
1. Turn Attack to 0 (=fully counterclockwise) and Sensitivity to 5 (=halfway/12 o’clock) and VR3
to 10 (=fully clockwise)
2. Turn the VR3 until you hear the effect swell correct and without volume loss.
NB the Sensitivity pot is used to adapt the effect to the amount of input the effect gets (like an input
boost). If you use a booster/fuzz in front of the effect, you will need to lower the Sensitivity to get
the optimal result.
Off board wiring
S
Tip
Sleeve
Sleeve
Output Jack
Input Jack
Cathode (short leg)
Anode (long leg)
Footswitch
Ring
R led
Tip
The LEDs requires a resistor (R led in the diagram) depending on the
type of LED you are using. To be safe use a 3k3 or 4k7 resistor. If
you want to be more exact then go here:
http://www.muzique.com/schem/led.htm
Blue = pin 1
White = pin 2
Yellow = pin 3