Lithium Grim Snail Gear, Инструкция по сборке

Страница: 6 / 9

Snail Gear v1.1
6
Besides the components mentioned in the table on the page 3, you will need:

2 input jacks . 2 mono jacks if you are not going to use a battery but only the 9V adapter. 1
mono (for output) and 1 stereo jack (for input) if you will be using both a 9V battery and the
9V adapter.

1x 3PDT footswitch (9 pins). I also sell an easy off board circuit for true bypass.

2,1mm DC jack (isolated).

9v battery clip (optional).

22 gage stranded hook-up wire.

1 x 3mm LED (and if needed a LED holder to mount it in the enclosure)

Hammond 1590B case (or similar) in your favorite color. A Hammond 1590BB will give you
more room to build especially when using the swell mod.
Modifications

Swell MOD. You can extend the swell time by changing C6 to a higher value. Especially for
this mod the SW1 is added to the board. If you do not decide to use the mod then leave out
the SW1. If you do want to use the mod, I suggest using a DP3T (ON/OFF/ON) switch with the
4.7uF on one side and eg. a 22uF on the other side. Experiment with different values before
you decide to do the mod. You could even make a rotary switch with even more values! The
lower you set the Attack, the longer the swell takes. In combination with a 22uF (C6) it is
about 0,5 seconds.
22
uF
+
-
4
.7
uF
+
-

The original uses a LM741 instead of a TL071.