7. Fan Assembly.
Remove motor assembly from temporary
hanging slot in hanging bracket. Carefully push
wiring and wire connectors into outlet box. Slide
one end of bar on motor assembly through one
of the openings in the hanging bracket. Lift the
other end of the and slide it through opposite
opening on hanging bracket. Align holes in top
of motor assembly with holes in hanging
bracket. Secure motor assembly to hanging
bracket with lock washers and motor mounting
screws that were previously removed (Section 5,
page 4).
8. Motor Housing Assembly.
Temporarily hold motor housing up to hanging
bracket to determine which 2 screws align with
slotted holes on top rim of motor housing. Put
motor housing down and
partially loosen
the 2
screws in the hanging bracket that correspond
to slotted holes in motor housing.
Remove
the
other
2 screws from the hanging bracket.
Raise motor housing to hanging bracket again,
allowing slotted holes in motor housing to
align with loosened screws in hanging bracket.
Twist motor housing to lock. Re-install the 2
screws that were previously removed and then
tighten all screws to secure motor housing.
page 5
motor
mounting
screws and
lock washers
motor
mounting
screws and
lock washers
hanging
bracket
opening
motor
housing
screws
motor
housing
screws
motor
housing
hanging
bracket
opening
slot
hanging
bracket
motor assembly