page 4
hanging
bracket
hanging
bracket slot
Remove 4 motor mounting screws and lock
washers from the bar on the top of motor
assembly; leave rubber cushions in place. Lift
motor assembly to hanging bracket and place
one end of motor assembly in hanging bracket
slot. This will allow motor assembly to hang out
of the way while wiring.
Tip
: Seek the help of another person to hold the
stepladder in place and to lift the fan up to you
once you are set on the ladder.
NOTE
:
See instructions above (Section 5) in order
to
temporarily
hang fan on hanging bracket
during wiring.
CAUTION
:
Be sure outlet box is properly grounded
and that a ground wire (
GREEN
or Bare) is present.
Make sure all electrical connections comply with
Local Codes or Ordinances and the National
Electrical Code. If you are unfamiliar with electrical
wiring or if the house/building wires are different
colors than those referred to in the instructions
below, please use a qualified electrician.
When fan is secured in place on the hanging
bracket, electrical wiring can be made as follows:
Connect
BLACK
and
BLUE
wire from fan to
BLACK
wire from ceiling with wire connector
provided.
Connect
WHITE
wire from fan to
WHITE
wire
from ceiling with wire connector provided.
Connect all
GROUND
(
GREEN
) wires from fan
together to
BARE
/
GREEN
wire from ceiling with
wire connector provided.
If you intend to control the fan light with a
separate light switch, connect
BLUE
wire from
fan to the
BLACK
supply from the independent
switch.
* Wrap each wire connector separately with
electrical tape as an extra safety measure.
motor assembly
motor
mounting
screws and
lock washer
5. Preparation for Wiring.
6. Wiring.
hanging
bracket
motor assembly
*
WHITE
WHITE
BLACK
BLACK
BLUE
GROUND (GREEN OR BARE)
GREEN
GREEN